Defining A Policy; Applying A Policy - H3C SecPath F1800-A Operation Manual

Operation Manual - Network and Routing Protocol
H3C SecPath F1800-A Firewall
Table 7-4 Re-designating a next hop
Re-designate a next hop.
Reset re-designating next hops.

7.2.4 Defining a Policy

I. Defining a Policy and Entering Policy View
Do as follows in system view.
You can use the qos policy command to define a policy and enter policy view.
Table 7-5 Defining a policy and entering policy view
Define a policy and enter policy view.
Delete the policy.
If this policy is applied in a security zone, you cannot delete it. To delete this policy,
you need to cancel this policy application in the security zone, and then use the undo
qos policy command.
II. Designating Traffic Behavior for a Class
Do as follows in policy view.
Table 7-6 Designating traffic behavior for a class
Designate a traffic behavior for a
class in the policy.
Cancel the application of a class.

7.2.5 Applying a Policy

One policy route can be applied in several security zones.
Do as follows in security zone view.
Action
Action
Action
5-128
Chapter 7 Policy Routing Configuration
Command
remark ip-nexthop
output-interface
interface-number }
undo remark ip-nexthop
Command
qos policy policy-name
undo qos policy policy-name
Command
classifier tcl-name
behavior-name
undo classifier tcl-name
nexthop-ip-address
{ interface-type
behavior