Replacing The Tn799C C-Lan Circuit Pack (If Necessary); Installing Tn771 Maintenance/Test; Connecting To The Media Server - Avaya S8700 Series Manual

Replacing the TN799C C-LAN circuit pack (if necessary)

To replace the TN799C C-LAN circuit pack:
1. Remove the TN799C Control-LAN (C-LAN) circuit pack and place it in an antistatic carrier
or bag.
2. Insert the new TN799DP C-LAN circuit pack into the same slot.
3. Replace the 259A adapter and CAT3 cable on the connector panel with the Amphenol
adapter used for the TN2302AP IP Media Processor circuit pack and a CAT5 cable.

Installing TN771 Maintenance/Test

Install a TN771 Maintenance/Test circuit pack in slot 1. There must be one TN771 Maintenance/
Test circuit pack per location. Maintenance functions were present on the TN798 or TN2402
Processor circuit pack and must be replaced by the TN771. This carrier does not have a TN775
Maintenance (EPN) dedicated slot.
If the cabinet does not have a TN2302AP IP Media Processor (CSI did not require it), then you
must install one in slot 10. See the Adding New Hardware book, Install and Administer IP
Connectivity Hardware section.

Connecting to the media server

Connect one end of the GREEN CAT5 straight-through cable to the Ethernet switch on the
customer's network and the other to the IPSI adapter on the back of the media gateway.
Converting a processor port network to a port network (CMC)
Issue 4 January 2005 115