What Is Ip Multicast Traffic - Dell PowerConnect 7048P Manual

discarded, depending on the switch configuration. If a match is found, then
the packet is forwarded only to the ports that are members of that multicast
group.
You can create multicast bridging groups and specify the ports and LAGs that
are members of each group. This allows L2 multicast traffic to be confined to
the specified group.
You can configure the forwarding mode for each VLAN as one of the
following:
• Forward Unregistered—Permits
This means that multicast streams that have no registrants (no hosts have
joined the multicast group) will be flooded.
• Filter Unregistered—Prohibits the forwarding of
such as router advertisements, RIP, and OSPF.
• Forward All—Permits registered and unregistered multicast packets to
forward.

What Is IP Multicast Traffic?

IP multicast traffic is traffic that is destined to a host group. Host groups are
identified by class D IP addresses, which range from 224.0.0.0 to
239.255.255.255.
When a packet with a broadcast or multicast destination IP address is
received, the switch will forward a copy into each of the remaining network
segments in accordance with the IEEE MAC Bridge standard. Eventually, the
packet is made accessible to all nodes connected to the network.
This approach works well for broadcast packets that are intended to be seen or
processed by all connected nodes. In the case of multicast packets, however,
this approach could lead to less efficient use of network bandwidth,
particularly when the packet is intended for only a small number of nodes.
Packets will be flooded into network segments where no node has any interest
in receiving the packet.
704
Configuring L2 Multicast Features
control multicast frames to be forwarded.
control multicast frames