Programming The Duress Code; Add And Delete Proximity Tags - Visonic PowerMaster-360R User Manual

Menus and functions
B.5 Programming the duress code
A duress alarm message can be sent to the monitoring station if you are forced to disarm the system. To initiate a
duress message, you must disarm the system using the duress code. By default this code is 2580.
A. To program the duress code
1.
DURESS CODE
2.
DURESS CODE 2580
3.
DURESS CODE 6973
☺

Return to step 1
For detailed instructions on how to select the setting options – refer to sections A.1 and A.2.
1
2
The display shows the default duress code (2580).
3
Do not set the duress code the same as an installer or user code.
To end this session and to select other menu options or to quit programming – follow the instructions in
4
section A.2.
B.6 Add and delete proximity tags
A proximity tag may be assigned to each of the user codes 1-48 that can be used instead of the user codes to
perform a variety of functions, for example, arming, disarming, reading the event log, etc.
Whenever a user code is required you can simply present a valid proximity tag instead of entering the user
code on devices such as KP-141 PG2 or KP-160 PG2. Each tag should be assigned with a serial No. 1-48 that
corresponds to the User Code No. 1-48 and correspondingly enrolled in the system.
The partition authorization of the tags has a different authorization than the users.
 Here you can add (enroll) new proximity tags or delete tags as required.
Carefully read the section titled "Additional information" according to the indicated references

table at end of this section.
A. To add (enroll) a proximity tag
1.
PROXIMITY TAGS
2. ADD NEW TAG
3.
ENROLL NOW or
ENTR ID:xxx-xxxx
4.
DEVICE ENROLLED
☺

Go to step 5
5.
T01:Tag (Prox)
24
Enter the [USER SETTINGS] menu, select the [DURESS CODE] option and
1
press .
At the blinking cursor position, enter the Duress Code, for example, 6973.
When the duress code you wish to program appears on the display, press
.
☺
A "Success Tune" 
Additional information (section B.5)
Enter the [USER SETTINGS] menu; select the [PROXIMITY TAGS] option
and press . 1
The display will read [ADD NEW TAG].
To begin the process of enrolling a new proximity tag, press
Present the proximity tag to the control panel within the timeout period.
If enrollment was successfully completed, a "Success Tune" ☺ sounds and
the display reads [DEVICE ENROLLED] for a short duration and then
changes to read the tag's details.
The display shows the allocated tag serial No (user No.), which is always the
first free number, for example: [T01:Tag (Prox)].
sounds. The display confirms the saved code.
3
4
D-307084 PowerMaster-360R User's Guide
2, 3
4
etc. – see
1
.