Enable Slb Failover - Extreme Networks ExtremeWare Command Reference Manual

enable slb failover

enable slb failover
enable slb failover
Description
Enables SLB failover.
Syntax Description
This command has no arguments or variables.
Default
Failover is disabled by default.
Usage Guidelines
When SLB failover is enabled, the primary SLB switch automatically resumes primary status when it
becomes active.
Before you enable SLB failover, configure your switches using the following command:
config slb failover unit
To disable SLB failover, use the following command:
disable slb failover
Example
The following command enables SLB failover:
enable slb failover
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all "i" series platforms.
ExtremeWare Software 7.0.0 Command Reference Guide 457