Config Slb Failover Ping-Check - Extreme Networks ExtremeWare Command Reference Manual

config slb failover ping-check

config slb failover ping-check <ip address> {frequency <seconds> timeout
<seconds>}
Description
Configures the SLB device to actively determine if a remote gateway is reachable by performing a ping.
Syntax Description
ip address
frequency
timeout
Default
The default frequency is 1 second.
The default timeout is 3 seconds.
Usage Guidelines
The frequency must be less than the timeout.
If the external gateway is not reachable, the virtual servers failover to the remote SLB device.
Do not configure ping-check to the remote SLB switch. If you configure ping-check to the remote SLB
switch and the remote switch fails, the local switch also fails.
Example
The following command sets the IP address of the remote gateway to 10.10.10.21 with a ping frequency
of 5 seconds and a timeout of 10 seconds:
config slb failover ping-check 10.10.10.21 frequency 5 timeout 10
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all "i" series platforms.
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies the IP address of the remote gateway.
Specifies the frequency of pings sent to the remote gateway. The range is 1 to 60.
Specifies the time before the local device declares the remote gateway down. The
range is 1 to 60.
config slb failover ping-check
363