Hitachi XP P9500 User Manual page 559

processing, enter
Paths Offline).
KAPL01054-W
During the offline operation processing of the HDLM command, a
path that cannot be placed in the Offline(C) status was detected.
PathID = aa...aa Would you like to continue the processing of the
offline operation? [y/n]:
Details
A path that cannot be set to Offline(C) was detected during multi-path offline
processing. To ignore this path and perform offline processing for the next path,
enter . To cancel offline processing, enter
y
aa...aa: Path ID (decimal (base-10) number)
Action
If you want to continue processing the
command for other paths, enter
For details on the
KAPL01055-I
All the paths which pass the specified aa...aa will be changed to
the Offline(C) status. Is this OK? [y/n]:
Details
Multiple paths will be collectively set to Offline(C) because the
parameter was specified. To collectively set multiple paths to Offline(C), enter
To cancel the operation, enter
aa...aa:
CHA
Action
If you want to execute
requirements, enter
KAPL01056-I
If you are sure that there would be no problem when all the paths
which pass the specified aa...aa are placed in the Offline(C)
status, enter y. Otherwise, enter n. [y/n]:
Details
This message re-asks the user whether they want to set all the paths to Offline(C).
To set all the paths to Offline(C), enter
aa...aa:
CHA
Action
. For details on the
n
. If you want to terminate processing, enter
y
operation, see 6.4 offline (Places Paths Offline).
offline
.
n
port or
HBA
processing for the paths that meet the specified
offline
. If you want to terminate processing, enter
y
port or
HBA
operation, see 6.4 offline (Places
offline
.
n
operation of the HDLM
offline
. To cancel the operation, enter
y
8. Messages
.
n
or
-hba -cha
.
y
.
n
.
n
535