Hitachi XP P9500 User Manual page 554

Hitachi dynamic link manager software user's guide for linux (6.x) (hit5203-96004, october 2011)

Hide thumbs Also See for XP P9500:

Table of Contents

Execute the view operation of the HDLM command (

and check the value displayed in PathName. Specify the two leftmost digits of

PathName for the relevant HBA port, and then retry. For details on the

operation, see 6.7 view (Displays Information).

The target path was not found. Operation name = aa...aa

The specified path does not exist.

The paths have not been configured because creation of the HDLM

environment or configuration changes to the HDLM operating environment

have not finished.

settings, and then retry. For details on the

(Displays Information).

Refer to3. Creating an HDLM Environment. Creating an HDLM

Environment or 4.6 Reconfiguring the HDLM Operating Environment, and

then configure any paths that exist. If the same message appears again,

acquire the error information, and then contact your HDLM vendor or the

company for which you have a service contract. For details on the

Information.

Cannot execute the HDLM command due to insufficient memory.

Memory required for HDLM command processing could not be allocated.

operation of the HDLM command (

utility for collecting HDLM error information,

utility, see 7.2 DLMgetras Utility for Collecting HDLM Error

dlnkmgr view -path

) to check the

operation, see 6.7 view

Chapters

Table of Contents

Dynamic link manager