Hitachi XP P9500 User Manual page 463

-lbpathusetimes
Times Same Path Was Used
KAPL01001-I The HDLM command completed normally. Operation
name = view, completion time = yyyy/mm/dd hh:mm:ss
#
(2) To display path information
When displaying path information, if you specify either the
and also specify the
a summary of path information. This section describes each parameter, path
information and displayed items.
To display path information
-path
When you specify the
parameter, the information will be displayed about the HDLM managed paths
without abbreviating or selecting items.
In the sub-parameters (following
using
-hdev
command displays information for all the paths in order of increasing
AutoPATH_IDs.
For details on what is displayed in each item, see Table 6-12: Path Information.
AutoPATH_IDs displayed by the
which HDLM detects the paths after a host is started up. Because of this, make
sure that you use the path name
The sub-parameters are as follows:
host-device-name
-hdev
Displays information only for the paths accessing the specified host device.
Specify the name of the logical device file (minus the partition number),
dev/sddlm
files for HDLM devices, see 2.6 Logical Device Files for HDLM Devices.
The host-device-name string is case-sensitive.
-stname
Use this parameter to display the model ID of the storage system in the
product ID element of the
the command displays the product ID or emulation type of the storage system
instead.
For details about the information displayed for product IDs, see
parameter, you can select the items to display and display
-path
parameter and do not specify either the
-path
-path
and sort the list using
-srt
-path
PathName
[aa-pap], for the HDLM device. For details on logical device
DskName
6. Command Reference
: 32
-item
), you can filter the paths to be listed
. When you omit both parameters, the
parameter depend on the sequence in
to identify a path.
field. When this parameter is omitted,
or parameter
-c
or
-c -item
/
439