Hitachi XP P9500 User Manual page 448

6. Command Reference
Setting
AFB IEM
Set IEM to
Set AFB to
off
Change the AFB setting.
Set AFB to
Set IEM to
#2 Set AFB to
off
on
Set AFB to
Set AFB to
off
Set AFB to
Legend:
AFB: Automatic failback
IEM: Intermittent error monitoring
#1
When this condition is not satisfied, the KAPL01080-W message is output and an
error occurs. The status of intermittent error monitoring does not change.
#2
Because automatic failback is
Example
The following example shows how to monitor for intermittent errors.
# /opt/DynamicLinkManager/bin/dlnkmgr set -iem on -intvl
20 -iemnum 2
KAPL01049-I Would you like to execute the operation?
Operation name = set [y/n]: y
KAPL01001-I The HDLM command completed normally.
Operation name = set, completion time = yyyy/mm/dd
hh:mm:ss
#
424
Available operation
.
off
.
on
.
off
.
on
.
on
.
off
.
on
.
off
off
Result of operation
• IEM is disabled.
• The error count, elapsed monitoring time, and
information about paths not subject to automatic
failbacks are cleared.
The operations of AFB and IEM do not change.
AFB operates using new settings.
AFB is disabled.
#1
IEM is enabled.
AFB and IEM are enabled.
The operations of AFB and IEM do not change.
AFB is enabled.
The operations of AFB and IEM do not change.
, intermittent error monitoring is disabled.
#1