Hitachi XP P9500 User Manual page 435

KAPL01057-I All the paths which pass the specified CHA
port will be changed to the Online status. Is this OK?
[y/n]:y
KAPL01061-I 2 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
#
AutoPATH_ID
-pathid
Use this parameter to place a single path online.
Specify the current AutoPATH_ID of the target path, which is displayed by using
the operation. For details about the
view
Information). Leading zeros can be omitted (
AutoPATH_ID); however, when the target AutoPATH_ID is
or for the parameter value.
000000 0
AutoPATH_IDs are re-assigned every time the host is restarted. When you want
to add a new LU without restarting the host, AutoPATH_IDs are re-assigned to
each path of the LU when you execute the
that you use the
view
path, before executing the
SCSI-device-name
-device
Use this parameter to place online a path connected to the specified SCSI device.
For SCSI-device-name, specify the value of
operation as follows:
view
# /opt/DynamicLinkManager/bin/dlnkmgr view -lu
For details on how to execute the
name, see (3) To display LU information in 6.7.2 Parameters (To display
program information). Only one case-sensitive parameter value can be specified.
Example
The following shows an example of how to place online a path whose SCSI
device name is
# /opt/DynamicLinkManager/bin/dlnkmgr online -path
-device /dev/sde
KAPL01050-I The currently selected paths will be changed
to the Online status. Is this OK? [y/n]:y
KAPL01061-I 1 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
-s
Executes the command without displaying the message asking for confirmation
of command execution from the user. Specify this parameter if you want to skip
view
dlmcfgmgr
operation to find the current AutoPATH_ID of the target
operation.
online
operation and display the SCSI device
view
while confirming command operation.
/dev/sde
6. Command Reference
operation, see 6.7 view (Displays
and indicate the same
000001 1
000000
utility. Always make sure
displayed by executing the
Device
, enter
411