Hitachi XP P9500 User Manual page 339

Figure 3-41: Example of Executing the dlmcfgmgr Utility with the -v Parameter
Specified
Figure 3-42: Example of Executing the dlmcfgmgr Utility with the -v and -udev
Parameters Specified
The ,
HDevName Device
devices, and
udev
4. Edit the
/etc/fstab
Change the mount points for the HDLM management-target devices that you
checked in step 2 from the HDLM device to the SCSI device. Comment out the
existing HDLM device specification by placing a hash mark (
of each line, and then add the SCSI device specification as shown below, based
on the correspondence between the HDLM device and SCSI device as checked in
step 3.
#/dev/sddlmaa2
/dev/sda2
For Red Hat Enterprise Linux 6, a block device name starting with
of a SCSI device name can be specified. If that is the case, go to step 5.
If you are using SUSE LINUX Enterprise Server 10, you can specify the device
name ( name) in the
udev
this case, go to step 5.
If LVM2 is used in cases other than above, go to step 6. If LVM2 is not used, go
, and columns display HDLM devices, SCSI
Udev
names, respectively.
file.
:
:
/ ext2
/ ext2
:
:
directory instead of the SCSI device. In
/dev/disk
3. Creating an HDLM Environment
) at the beginning
#
defaults 1 1
defaults 1 1
instead
UUID=
315