Hitachi XP P9500 User Manual page 265

The following example shows how to execute the
disk partition type to
# fdisk /dev/sddlmaa
Command (m for help): p
Disk /dev/sddlmaa: 5368 MB, 5368709120 bytes
166 heads, 62 sectors/track, 1018 cylinders
Units = cylinders of 10292 * 512 = 5269504 bytes
Device Boot
/dev/sddlmaa1
autodetect
Command (m for help): t
Selected partition 1
Hex code (type L to list codes): 83
Changed system type of partition 1 to 83 (Linux)
Command (m for help): p
Disk /dev/sddlmaa: 5368 MB, 5368709120 bytes
166 heads, 62 sectors/track, 1018 cylinders
Units = cylinders of 10292 * 512 = 5269504 bytes
Device Boot
/dev/sddlmaa1
Command (m for help): w
The partition table has been altered!
Calling ioctl() to re-read partition table.
Syncing disks.
Also perform the above operation for
16. Execute the following command to activate the md device:
# mdadm -As /dev/md0
mdadm: /dev/md0 has been started with 2 drives.
17. Make sure that the md device has been activated.
In the following example, RAID1 (mirroring) is used for the md device:
# cat /proc/mdstat
Personalities : [raid1]
md0 : active raid1 sddlmaa1[0] sddlmab1[1]
:
83
Start End
1 1018
Start End
1 1018
/dev/sddlmab
3. Creating an HDLM Environment
command to change the
fdisk
Blocks Id System
5238597 fd Linux raid
Blocks Id
5238597 83
.
System
Linux
241