Hitachi XP P9500 User Manual page 248

3. Creating an HDLM Environment
30. In
initrd
If you are using a kernel that supports Xen, change the
specified in
When an option that depends on the user environment is specified, be careful not
to delete the option.
31. Specify the configuration that will be used for booting.
• When GRUB is the boot loader
Specify the position of the valid
• When ELILO is the boot loader
Specify
32. Shut down the host.
Execute the following command to shut down the host:
# shutdown -h now
33. Change the configuration from a single-path configuration to a multi-path
configuration.
34. Start the host.
35. Execute the
.
/boot
The following shows an execution example for when
loader:
# mount
/dev/sddlmaa1 on /boot type ext3 (rw)
Check the underlined section.
36. Update the information about the volume group.
Execute the following command to update the information about the volume
group.
# vgscan
Reading all physical volumes.
224
, specify the initial RAM disk image file you created in step 23.
to the initial RAM disk image file you created in step 23.
module
for .
label default
command to make sure that the HDLM device is mounted on
mount
:
:
:
:
initrd
for .
title default
is used as the boot
GRUB
This may take a while...
file name