Hitachi XP P9500 User Manual page 226

3. Creating an HDLM Environment
that uses
instead of
displayed as
7. If necessary, back up the
8. Edit the
/etc/fstab
Refer to the correspondence between
checked in step 4.
Copy the registration of the
Comment out the existing settings.
Edit the file to disable the
specification.
9. Restart the host to make sure that booting from the SCSI device is possible.
This completes the removal of the
10. Install HDLM.
To install HDLM, see 3.6.2 Performing a New Installation of HDLM perform
steps 2 to 12 to create an HDLM device. You will also need to perform step 13 if
you are only restarting the host. Note that the procedure differs depending on
whether the host is restarted after installation.
In steps 12 to 27 that follow, you will edit the configuration file to change the
definition so that the OS starts with HDLM specified.
11. Execute the HDLM-configuration definition utility (
parameter specified to check the correspondence between the HDLM device and
the SCSI device.
# dlmcfgmgr -v
HDevName
/dev/sddlmaa configured /dev/sda
KAPL10302-I /sbin/dlmcfgmgr completed normally.
The
HDevName
indicates the SCSI device.
12. Edit the
/etc/lvm/lvm.conf
device, not the SCSI device.
Figure 3-11: Example of Editing /etc/lvm/lvm.conf file shows examples of
editing the
202
as the boot loader, the mount point is displayed as
ELILO
(in the line where
/boot
instead of
vfat ext3
/etc/fstab
file.
LABEL
LABEL
Management Device
column indicates the HDLM device, and the
file so that the LVM2 recognizes the HDLM
/etc/lvm/lvm.conf
is coded), and the file system type is
/boot
.
file.
and the SCSI device that you
LABEL
specification.
specification and enable the SCSI device
setting.
LABEL
dlmcfgmgr)
Host Channel Target Lun
0
file.
/boot/efi
with the
-v
0 0 0
column
Device