Hitachi XP P9500 User Manual page 186

3. Creating an HDLM Environment
# /media/cdrom/installux.sh
• When executing the
# /media/cdrom/HDLM_Linux/installhdlm
6. The KAPL09093-I message is displayed to confirm that you want to perform an
upgrade installation. Check the HDLM version, and if it is correct, enter
7. Make sure that HDLM is installed.
Execute the following command to display detailed information about the
installed package.
# rpm -qi HDLM
Name
Version
Release
:
If
HDLM Version
x.x.x.x.xxx indicates the HDLM version that was installed.
8. If IP-SAN is used for the connection between the host and the storage system,
change
iscsi_boot=n
hdlm.conf
9. When you want to set the HDLM driver options, run the
setting HDLM driver option.
For details on this utility, see 7.6 dlmsetopt Utility for Setting HDLM Driver
Options.
If you performed this step, go to step 12.
10. When you want to install HDLM without restarting the host, go to step 11. When
you want to install HDLM with restarting the host, then go to step 12.
11. Execute the
For details, see 7.7 dlmstart Utility for Starting HDLM.
12. Add
/opt/DynamicLinkManager/bin
the environment setup file for the shell used by the root user.
Add the following code to the
162
installhdlm
: HDLM
x.x.x.x.xxx
:
xx
:
is x.x.x.x.xxx, the installed version of HDLM is correct.
, written in the
file, to
iscsi_boot=y
utility for starting HDLM.
dlmstart
PATH
utility
/etc/opt/DynamicLinkManager/
.
dlmsetopt
in the environment variable
environment variable in the environment
.
y
utility for
in
PATH