Creating Cartridges; Create Virtual Library Wizard Window (6 Of 12) - HP StorageWorks 12000 - Virtual Library System EVA Gateway User Manual

5. Click Next Step.
The next Tape Drive Parameters window opens
Figure 39 Create Virtual Library Wizard window (6 of 12)
.
6. Enter the number of tape drives you want to create in the library at this time in the Tape Drives
box, if different from the default value.
You can add more tape drives to the library later. The Tape Drives box defaults to the standard
number of drives for the library type.
NOTE:
All the tape drives created at one time are mapped to the same Fibre Channel host ports.
Make sure to load-balance the tape drives across the Fibre Channel host ports to obtain
maximum performance. Tape drives in a library do not have to be mapped to the same
port as the library.
7. Click Create Tape Drive.
A summary window opens and displays details about the tape drives created.
8. Choose one of the following options:
• To perform LUN mapping for the virtual tape drive, click Map LUNs and proceed to
"LUN Mapping
• To create more tape drives, click Create More Tape Drives.
• To add cartridges to the virtual library, click Create Cartridges and proceed to
"Creating
• To exit the wizard, click Cancel.
At this point the library and tape drives have been created, but the library does not contain
any cartridges. You can add cartridges later.

Creating Cartridges

To add cartridges to a virtual library:
(v3.x)" on page 123 for further instructions.
Cartridges" on page 135.
(Figure 39).
HP StorageWorks 135