What Do I Do If Most Of My Physical Attributes Catagories Disappear?; What Do I Do If I Can't See The Information Pane?; Can I Create A Zone With Prefix Ivrz Or A Zone Set With Name Nozonset?; What Do I Do When One-Click License Install Fails, And I Cannot Connect To The Cisco Website? - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Chapter 69 Management Software FAQ
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Some older video cards exhibit these display anomalies. To fix this, first try updating the video drivers.
If this doesn't solve the problem, replace the video card.

What do I do if most of my Physical Attributes catagories disappear?

You have somehow turned off advanced features. Look for the check box Advanced Features in the upper
right of the Fabric Manager screen. Check the box.

What do I do if I can't see the Information pane?

The information pane should be in the upper half of the screen above the map in Fabric Manager. The
map my be covering it. Drag the edge of the map window down or use the black triangles to reorganize
the display.
Why is the active zone set in edit zone always shown in bold (even after
successful activation)?
A member of this VSAN must be participating in IVR zoning. Because the IVR zones get added to active
zones, the active zone set configuration is always different from the local zone set configuration with the
same name. The zone set name is always bold.

Can I create a zone with prefix IVRZ or a zone set with name nozonset?

Do not use these special names. These names are used by the system for identifying IVR zones.
What do I do when One-Click License Install fails, and I cannot connect to the
Cisco website?
The one-click license install tries to open an HTTP connection to the Cisco website. If you do your
browsing using an HTTP proxy then the following command- line variables need to be added to your
Fabric Manager client scripts:
-Dhttps.proxyHost and -Dhttps.proxyPort.
In case your one-click install URL starts with "http://" (and not "https://"), the variables are:
-Dhttp.proxyHost and -Dhttp.proxyPort.
For example, in Windows, edit the MDS 9000\bin\FabricManager.bat file and add to the JVMARGS
"-Dhttps.proxyHost=HOSTADDRESS -Dhttps.proxyPort=HOSTPORT".
OL-8007-10, Cisco MDS SAN-OS Release 3.x
Cisco MDS 9000 Family Fabric Manager Configuration Guide
General
69-9