Running Cli Commands - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Chapter 68 Troubleshooting Your Fabric
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Running CLI Commands

Running CLI Commands
As of Cisco MDS SAN-OS Release 3.1(2), you can use the Run CLI Commands feature to run a CLI
command on multiple switches.
To run CLI commands using Fabric Manager, follow these steps:
Step 1 Choose Tools > Run CLI Commands.
You see the Run CLI Commands dialog box with all switches selected as shown in
Figure 68-8
Deselect the check box for the switch(es) for which you do not want to run CLI commands.
Step 2
Specify where you want the file to be saved.
Step 3
Note
Enter the command(s) in the Command(s) text box. If the commands are configuration mode commands,
Step 4
you must also enter the exit command.
Note
Click OK to run the CLI command(s).
Step 5
You see the Run CLI Commands dialog box showing the status of each switch as shown in
OL-8007-10, Cisco MDS SAN-OS Release 3.x
Run CLI Commands Dialog Box
A separate report is issued for each switch. Check the reports to verify whether a CLI command
failed.
For the commands to execute, you cannot be in configuration mode.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Running CLI Commands
Figure 68-8.
Figure 68-9.
68-11