Configuring A Static Route - Cisco CRS Configuration Manual

Implementing MPLS VPNs over IP Tunnels
DETAILED STEPS
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 route-policy name pass
Example:
RP/0/RP0/CPU0:router(config)# route-policy ottawa_admin pass
Defines and passes a route policy.
Step 3
end policy
Example:
RP/0/RP0/CPU0:router(config-rpl)# end policy
End of route-policy definition.

Configuring a Static Route

Perform this task to add more than 4K static routes (Global/VRF).
SUMMARY STEPS
1. configure
2. router static
3. maximum path ipv4 1-140000
4. maximum path ipv6 1-140000
5. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 router static
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
Configuring a Static Route
43