Configuring Route Policy For Static Rpf - Cisco XR12000 Series Configuration Manual

Configuring Route Policy for Static RPF

Command or Action
Step 4
Use the commit or end command.
Configuring Route Policy for Static RPF
SUMMARY STEPS
1. configure
2. router static
3. address-family[ipv4 | ipv6][ multicast |unicast]destination prefix interface-typeinterface-path-id
4. exit
5. route-policypolicy-name
6. set rpf-topology policy-nameaddress-family[ipv4 |ipv6]multicast | unicasttopologyname
7. end route-policy
8. router pim address-family[ipv4 |ipv6]
9. rpf topology route-policypolicy-namepim policy
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/0/CPU0:router# configure
Step 2 router static
Example:
RP/0/0/CPU0:router(config) # router static
Cisco IOS XR Multicast Configuration Guide for the Cisco XR12000 Series Router, Release 5.1.x
90
Implementing Multicast Routing on Cisco IOS XR Software
Purpose
commit—Saves the configuration changes, and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without committing
the configuration changes.
Purpose
Enters global configuration mode.
Enables a static routing process.
OL-30405-02