Implementing MPLS Transport Profile
Command or Action
Configuring Pseudowire OAM Attributes
Perform this task to configure pseudowire OAM attributes.
SUMMARY STEPS
1. configure
2. l2vpn
3. pw-oam refresh transmit value
4. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2
l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Step 3
pw-oam refresh transmit value
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)#
pw-oam refresh transmit 20
Step 4
Use the commit or end command.
OL-28381-02
Purpose
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Enters L2VPN configuration mode.
Specifies the OAM timeout refresh intervals.
commit—Saves the configuration changes and remains within the
configuration session.
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuring Pseudowire OAM Attributes
319