Configuring Pseudowire Oam Attributes - Cisco ASR 900 Series Manual

Configuring Pseudowire OAM Attributes

Command or Action
Step 3
bfd-template single-hop template-name
Example:
Device(config)# bfd-template single-hop mpls-bfd-1
Step 4 interval [microseconds] {both time | min-tx time min-rx
time} [multiplier multiplier-value]
Example:
Device(config-bfd)# interval min-tx 99 min-rx 99
multiplier 3
Step 5 end
Example:
Device(config-bfd)# exit
Configuring Pseudowire OAM Attributes
SUMMARY STEPS
1. enable
2. configure terminal
3. pseudowire-static-oam class class-name
4. timeout refresh send seconds
5. exit
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
22
Purpose
Creates a BFD template and enter BFD configuration
mode.
Specifies a set of BFD interval values.
Exits BFD configuration mode and returns to
privileged EXEC mode.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
MPLS Transport Profile