Bfd Over Mpls Te Lsps: Examples; Bfd Over Mpls Te Tunnel Head-End Configuration: Example; Bfd Over Mpls Te Tunnel Tail-End Configuration: Example; Where To Go Next - Cisco ASR 9000 Series Configuration Manual

BFD over MPLS TE LSPs: Examples

BFD over MPLS TE LSPs: Examples
These examples explain how to configure BFD over MPLS TE LSPs.

BFD over MPLS TE Tunnel Head-end Configuration: Example

This example shows how to configure BFD over MPLS TE Tunnel at head-end.
bfd multipath include loc 0/1/CPU0
mpls oam
interface tunnel-te 1 bfd fast-detect
interface tunnel-te 1
bfd minimum-interval
bfd multiplier
bfd bringup-timeout
bfd lsp-ping interval 60
bfd lsp-ping disable
bfd dampening initial-wait
bfd dampening maximum-wait
bfd dampening secondary-wait
logging events bfd-status

BFD over MPLS TE Tunnel Tail-end Configuration: Example

This example shows how to configure BFD over MPLS TE Tunnels at tail-end.
bfd multipath include loc 0/1/CPU0
mpls oam
mpls traffic-eng bfd lsp tail multiplier 3
mpls traffic-eng bfd lsp tail minimum-interval 100

Where to Go Next

BFD is supported over multiple platforms. For more detailed information about these commands, see the
related chapters in the corresponding Cisco IOS XR Routing Command Reference and Cisco IOS XR MPLS
Command Reference for your platform at:
http://www.cisco.com/en/US/products/ps5845/prod_command_reference_list.html
• BGP Commands on Cisco IOS XR Software
• IS-IS Commands on Cisco IOS XR Software
• OSPF Commands on Cisco IOS XR Software
• Static Routing Commands on Cisco IOS XR Software
• MPLS Traffic Engineering Commands on Cisco IOS XR Software

Additional References

The following sections provide references related to implementing BFD for Cisco IOS XR software.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
236
(default 16000 ms)
(default 600000 ms)
(default 20000 ms)
Implementing BFD
OL-30423-03