Configuring Hierarchical Modular QoS on Cisco ASR 9000 Series Routers
Command or Action
Step 9
end
or
commit
Example:
RP/0/RSP0/CPU0:router(config-pmap-c-police)#
end
or
RP/0/RSP0/CPU0:router(config-pmap-c-police)#
commit
Configuration Examples for Hierarchical QoS
This section provides the following configuration examples:
•
•
•
•
•
•
Two-Level Hierarchical Queueing Policy: Example
The following example shows a two-level policy applied at the Multilink Frame Relay main interface.
The same policy can be applied at Multilink PPP main interface.
class-map match-any video
match precedence 1
end-class-map
!
class-map match-any premium
match precedence 2 3
end-class-map
!
class-map match-any voice-ip
match precedence 0
end-class-map
!
OL-23108-02
Two-Level Hierarchical Queueing Policy: Example, page 143
Three-Level Hierarchical Queueing Policy: Examples, page 144
Three-Parameter Scheduler: Examples, page 148
Hierarchical Policing: Examples, page 149
Attaching Service Policies to Physical and Virtual Links: Examples, page 150
Enhanced Hierarchical Ingress Policing: Example, page 150
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
Configuration Examples for Hierarchical QoS
Purpose
Saves configuration changes.
•
When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
–
Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
Entering no exits the configuration session and
–
returns the router to EXEC mode without
committing the configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or
committing the configuration changes.
Use the commit command to save the configuration
•
changes to the running configuration file and remain
within the configuration session.
QC-143