Configuring Eigrp Interfaces - Cisco Catalyst 9500 series Configuration Manual

Configuring IP Unicast Routing
Step 10
Step 11
Step 12

Configuring EIGRP Interfaces

Other optional EIGRP parameters can be configured on an interface basis.
Procedure
Step 1
Step 2
Step 3
Command or Action
end
Example:
Device(config)# end
show ip protocols
Example:
Device# show ip protocols
copy running-config startup-config
Example:
Device# copy running-config
startup-config
Command or Action
configure terminal
Example:
Device# configure terminal
interface interface-id
Example:
Device(config)# interface
gigabitethernet 1/0/1
ip bandwidth-percent eigrp percent
Example:
Device(config-if)# ip
bandwidth-percent eigrp 60
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
Configuring EIGRP Interfaces
Purpose
Returns to privileged EXEC mode.
Verifies your entries.
For NSF awareness, the output shows:
*** IP Routing is NSF aware *** EIGRP NSF
enabled
(Optional) Saves your entries in the configuration
file.
Purpose
Enters the global configuration mode.
Enters interface configuration mode, and specifies
the Layer 3 interface to configure.
(Optional) Configures the percentage of bandwidth
that can be used by EIGRP on an interface. The
default is 50 percent.
111