User Interface For Syslog; User Interface For Traceroute; User Interface For Ftp And Tftp - Cisco 3845 - Security Bundle Router Software Manual

Configuring Multi-VRF CE
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3 no switchport
Step 4
ip vrf forwarding <vrf-name>
Step 5
ip address ip address
Step 6
standby 1 ip ip address
Step 7
end

User Interface for Syslog

Beginning in privileged EXEC mode, follow these steps to configure VRF-aware services for Syslog.
For complete syntax and usage information for the commands, refer to the switch command reference
for this release and the Cisco IOS Switching Services Command Reference, Release 12.2.
Command
Step 1
configure terminal
Step 2
logging on
Step 3
logging host ip address vrf vrf name
Step 4 logging buffered logging buffered size
debugging
Step 5
logging trap debugging
Step 6
logging facility facility
Step 7
end

User Interface for Traceroute

Beginning in privileged EXEC mode, follow these steps to configure VRF-aware services for traceroute.
For complete syntax and usage information for the commands, refer to the switch command reference
for this release and the Cisco IOS Switching Services Command Reference, Release 12.2.
Command
traceroute vrf vrf-name ipaddress

User Interface for FTP and TFTP

So that FTP and TFTP are VRF-aware, you must configure some FTP/TFTP CLIs. For example, if you
want to use a VRF table that is attached to an interface, say E1/0, you need to configure the CLI ip [t]ftp
source-interface E1/0 to inform [t]ftp to use a specific routing table. In this example, the VRF table is
Cisco ME 3800X and 3600X Switch Software Configuration Guide
29-86
Purpose
Enter global configuration mode.
Enter interface configuration mode, and specify the Layer 3 interface to
configure.
Remove the interface from Layer 2 configuration mode if it is a physical
interface.
Configure VRF on the interface.
Enter the IP address for the interface.
Enable HSRP and configure the virtual IP address.
Return to privileged EXEC mode.
Purpose
Enter global configuration mode.
Enable or temporarily disable logging of storage router event message.
Specify the host address of the syslog server where logging messages
are to be sent.
Log messages to an internal buffer.
Limit the logging messages sent to the syslog server.
Send system logging messages to a logging facility.
Return to privileged EXEC mode.
Purpose
Specify the name of a VPN VRF in which to find the destination
address.
Chapter 29 Configuring IP Unicast Routing
OL-23400-01