Displaying And Maintaining Hotfix; Hotfix Configuration Examples - 3Com 4210G Series Configuration Manual

Displaying and Maintaining Hotfix

To do...
Display the patch information

Hotfix Configuration Examples

Hotfix Configuration Example (Single Device)
Network requirements
The software running on Device is of some problem, and thus hotfixing is needed.
The patch file patch_xxx.bin is saved on the TFTP server.
The IP address of Device is 1.1.1.1/24, and IP address of TFTP Server is 2.2.2.2/24. An available
route exists between Device and TFTP server.
Figure 23-6 Network diagram of hotfix configuration
Configuration procedure
1) Configure TFTP Server. Note that the configuration varies depending on server type and the
configuration procedure is omitted.
Enable the TFTP server function.
Save the patch file patch_xxx.bin to the directory of the TFTP server.
2) Configure Device
Make sure the free flash space of the device is big enough to store the patch file.
# Before upgrading the software, use the save command to save the current system configuration.
The configuration procedure is omitted.
# Load the patch file patch_xxx.bin from the TFTP server to the root directory of the device storage
medium.
<Device> tftp 2.2.2.2 get patch_xxx.bin
# Install the patch.
<Device> system-view
[Device] patch install flash:
Patches will be installed. Continue? [Y/N]:y
Use the command...
display patch information
23-9
Remarks
Available in any view