Step 5: Remove Front Drive Panel - Digital Equipment DEC 3000 700 AXP Upgrade Information

Upgrade Procedure
Step 5:
1. Loosen the two captive screws that hold the front drive panel
Remove Front
Drive Panel
2. Loosen the two captive screws on the back of the drive
3. If there is a drive inside the bracket, disconnect the SCSI
4. Pull up carefully from the back of the drive bracket. As you
5. Release the cables from the cable clamps on the inside of the
6. Set the front panel aside. Handle it carefully if it contains a
3–4 Upgrading a DECstation 5000 Model 120/125/133/150
in place.
bracket.
and power cables from the drive.
Captive
Screws
raise the end of the bracket, you can pull the disconnected
ends of the cables through the cutout in the bracket.
front panel.
drive.
Captive
Screws
MLO-010666