Channel-To-Port Assignment Configuration Options For Mcmp - Paradyne COMSPHERE 3610 Operator's Manual

Channel-to-Port Assignment Configuration Options for MCMP *

AssgmntPrt1: A
Next A B C
Channel Assignment to Port 1 . At the control site, any of the six channels (A—F) can be assigned to any of
the six ports (e.g., channel F
sharing, the same channel is assigned to both ports of the group). At one or more tributary sites, a channel
can be assigned to as many ports as wanted to establish the virtual multiport circuit for that channel when
Port Control is set to Host.
A to F — Assigns one of 6 channels to Port 1.
None — Assigns no channel to Port 1.
Choosing a channel assignment for Port 1 and pressing Next brings up the channel selection menu for
Port 2. Continue selecting channel assignments until channels have been assigned to all six ports if 6-port
MCMP/Flex is installed. Two ports will appear if 2-port MCMP/Flex installed. (The default for Ports 2—6
is None.)
* Only appears when MUX Funct is set to MCMP.
3610-A2-GB91-90
Table 6-17
D E F None
Port 1), but you cannot assign a channel to more than one port (for FEP port
July 1999
Prev
Configuration Options
6-55