Wire Switched 56 Dbm Or Dbm-D Technical Specifications; Hubbing Device Technical Specifications - Paradyne COMSPHERE 3610 Operator's Manual

COMSPHERE 3600 Series Data Service Units

2-Wire Switched 56 DBM or DBM-D Technical Specifications

Specifications
APPLICATION
COMMUNICATION LINE
DATA RATES
DBM COMPATIBILITY
SWITCHED 56 KBPS
NETWORK INTERFACE
3610 DSU
3611 DSU
APPROVALS
DOC
Certification Number
Load Number
NETWORK COMPATIBILITY
Specifications
APPLICATION
NETWORK MANAGEMENT
INTERFACES
NMS
PHYSICAL DIMENSIONS
Height
Width (thickness)
Depth
WEIGHT
1-36
Table 1-12
Full- or half-duplex data transmission via 56 kbps switched
services compatible with AT&T, US SPRINTr, and MCIr using
DataPatht 2-wire switched access to a local exchange carrier
(LEC) or an interexchange carrier (IEC).
A dedicated 2-wire access or a local exchange carrier 2-wire
switched access.
56 kbps (Note that the 2-wire Switched 56 DBM or DBM-D uses
proprietary rate adaption to support data rates of less than
56 kbps.)
If Call Setup is set for Callback or Password security, then the
device is compatible with a 3600 Series Switched 56 DBM only.
If Call Setup is set for Alarm or None, then any Switched
56 kbps terminal interface unit (TIU) can be used.
6-pin modular jack, USOC SJA48
(One or two) 50-pin connectors
230 5870 A
0
Northern Telecom NIS S204-2e 1986
Table 1-13

3600 Hubbing Device Technical Specifications

Diagnostic interfaces for the Model 3610 DSU
Two 8-pin modular jacks (Note that the 3600 Hubbing Device
has a 6-inch attached cable that terminates in a 4-pin modular
plug.)
1.9 inches (4.8 cm)
0.9 inches (2.3 cm)
3.4 inches (8.6 cm)
0.13 pounds (0.06 kg)
July 1999
Criteria
Criteria
3610-A2-GB91-90