Paradyne COMSPHERE 3610 Operator's Manual page 269

COMSPHERE
3600 Series 3600 Series
6700/6800
DSU DSU
ADp or DPII Mode
Stat:CirQ Circuit Quality
CCN Display/
—
Reset
CCN Enable/
—
Disable
Stat:H/S Health and Status
Bckup:Dial Dialing Command
Bckup: Dial Dial Mode
Bckup:
Dial Standby
DDS
Test:DT Digital Test
Ctrl:TxCtl Disable/Enable
Change External
Ctrl:ExtL
Leads
Display External
Ctrl:ExtL
Leads
1
The disruptive effect of most commands depends on the position of the addressed device in the circuit and
the setting of the Diagnostic Type configuration option. Commands addressed to a control DSU use the
NMS control channel (CC) or diagnostic channel (DC), and are nondisruptive to the primary data channel.
Since a tributary is remote, commands addressed to it can be disruptive unless the associated DBMs are in
Standby mode or the DSU is configured for nondisruptive mode.
E = If the DSU is configured for disruptive or mixed diagnostics, this command may cause errors
requiring retransmission of data. If the DSU is configured for nondisruptive diagnostics, this
command will not cause errors in the user data.
N = Nondisruptive.
D = Session-disruptive.
4
For DSUs with firmware version 4.25 or greater, a 6700 or 6800 Series NMS Release 3.0 is required to fully
support this command functionality.
8
Session-nondisruptive but will cause errors requiring retransmission of data.
3610-A2-GB91-90
Table H-1
(2 of 4)
NMS Command Set
System System
Controller Controller
—
—
—
4
Health and Status
Dialing Command
—
—
Transmission Test
Disable/Enable
—
—
July 1999
ANALYSIS ANALYSIS
6510 6510
Control
— N
— N
— N
Autoscan, N
Diagnostic
Self Test
— N
8
— E
8
— E
Digital Test D
Disable/
D
Enable
— N
— N
NMS Commands Reference
Disruptive
1
Effect
Trib
E
E
E
E
—
8
E
8
E
D
D
E
E
H-3