Paradyne COMSPHERE 3610 Operator's Manual page 185

SNA Backup:Disab
Next Enab Disab
SNA Backup . Allows the DSU to respond to the NetViewt commands for establishing and dropping a dial
backup command (Call Out and Disconnect). When the SNA Backup configuration option is disabled,
backup can still be controlled from a Paradyne NMS; SNA Backup need only be turned ON at the control
DSU. For extended circuit configurations, the extended circuit link can also be configured to respond to the
Netview dial backup command by turning on SNA Backup at the extended control DSU. This feature is not
supported in multipoint configurations.
Enab — The 3600 Series DSU control responds to the NetView dial backup command.
Disab — The 3600 Series DSU control sends a Request Not Supported by DCE message to NetView
upon receiving a dial backup command.
Code 1: 582210
Next Chang Prev
Code 1 . Determines the DSU type and model that the 3600 Series DSU reports to NetView for the DSU/CSU
and Line Status test and Transmit/Receive Test commands. The default values are the type (5822) and
model (10) of the IBM 5822, which the standalone 3610 DSU emulates for LPDA-2 monitoring. The default
values are 5822 and 18 for the carrier-mounted 3611 DSU. This value can be changed, but NetView may
report an error if the value is not a known IBM model number.
Code 2: 5822101
Next Chang Prev
Code 2 . Determines the DSU type and model that the DSU reports to NetView for the Call Out and the
Disconnect commands. This configuration option is normally set to the same value as Code 1. The last digit
in the configuration option is used to tell NetView that the DSU is either calling itself a DSU (1) or an APL
modem (0) when responding to a NetView Dial Backup command. It is needed because the NetView dial
backup commands are meant for APL devices and a particular release of NetView may not expect a DSU
device to respond to an APL specific command.
3610-A2-GB91-90
Table 6-18
(2 of 2)
LPDA-2 Configuration Options
Prev
July 1999
Configuration Options
6-57