Nms Commands Reference - Paradyne COMSPHERE 3610 Operator's Manual

NMS Commands Reference

Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Overview
The 3600 Series DSUs respond to the commands listed
in Table H-1. These commands are in the command sets
of the following network management systems:
COMSPHERE 6700 or 6800 Series NMS,
operating in ADp mode or Mixed mode —
Release 3.0 or greater is required to fully support a
3600 Series DSU with firmware version 4.25 or
greater, and is also required to support the new
configuration options and option choices as well as
new Device Health and Status information.
3610-A2-GB91-90
DATAPHONE II System Controller (and
Diagnostic Console and Network Controller, except
for dial-related commands) — Release 4.0 or
greater.
ANALYSIS 6510 NMS — Release 6.0 or greater.
Most tests and commands are similar to the commands
from the DCP.
July 1999
H
H-1
H-1