Control Function Menu Selection Screen; Changing External Leads - Paradyne COMSPHERE 3610 Operator's Manual

COMSPHERE 3600 Series Data Service Units

Changing External Leads

The External Leads configuration option must be set
before external leads can be displayed or changed. To set
external leads, select Confg, Opts, Activ, Gen, and Ext
Leads. Select ExtLd.
"
Procedure
1. From the Second-Level Menu screen
(Figure D-3):
PRESS: 5 – Ctrl
2. The Control Function Menu selection screen
appears (Figure D-5).
PRESS: 3 – ExtL
3. The External Leads Menu selection screen
appears (Figure D-6).
PRESS: 2 – Chang
1 – TxCtl
2 – LEDs
3 – ExtL
PRESS Desired Selection Key
D-6
Customer ID: SITER818
Control Funct:
Figure D-5. Control Function Menu Selection Screen
4. The External Leads Input screen appears
(Figure D-7). The OutA or OutB field will be
highlighted. To change the value of the bolded
field:
PRESS: 1 – Toggle
The highlighted field will change from high to
low or vice versa. At the DCP, the
instead. To move between the OutA and OutB
fields, use the < Tab> key on the keyboard. At
the DCP, the
5. If the value of either field is changed:
PRESS: 2 – Save
For further details regarding external leads, refer to
the External Leads section of Chapter 4.
Model: COMSPHERE 3610
T/ C t r l – T = Top Menu
U/ C t r l – U = Up Menu
C t r l – x = Disconnect
July 1999
key is used
or keys are used instead.
3610-A2-GB91-90