Operation Verification; Overview; Mcmp Initialization Procedure - Paradyne COMSPHERE 3610 Operator's Manual

Overview

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

MCMP Initialization Procedure

Start-Up Procedure
Verification Procedure
Central-Site Procedure
Remote-Site Procedure
Overview
After installing and configuring a network (including
control and tributary DSUs, the DDS network and, if
appropriate, DBMs and their network connections),
perform the following series of tests from the control
DSU, using the diagnostic control panel (DCP) or an
NMS, to verify that the equipment has been set up
correctly and to verify network operation.
You should be familiar with DCP operation and the
menu structure before beginning these procedures. If
necessary, refer to Chapter 4
MCMP Initialization Procedure
This section provides start-up and network verification
information for a DSU optioned with MCMP only. If the
MCMP option is not installed, proceed to the
Procedure section.
The Acquire Poll List command must be issued from
the control DSU's DCP the first time MCMP is activated
in the network and each time the network is reconfigured.
This command starts the initialization process. During
initialization, the control DSU with MCMP determines
the addresses of all tributary DSUs on the network.
3610-A2-GB91-90

Operation Verification

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
of this manual.
Verification
Start-Up Procedure
For either Model 3610 or 3611 DSUs with MCMP,
perform the Acquire Poll List (Acq) command on the
control DSU.
To the access Acquire Poll List command from the
top-level menu, make the following selections:
Local
Confg
PList
Acq
When any required menu item is
not displayed, press the
key to scroll menu selections
into view.
Verify that the address of each tributary DSU with
DBM has been acquired. (DBMs are acquired in
nondisruptive mode only.)
July 1999
5
5-1
5-1
5-1
5-2
5-2
5-5
NOTE
or
5-1