Paradyne COMSPHERE 3610 Operator's Manual page 219

Message
Inval lowest Prt
Invalid Port Spd
3610-A2-GB91-90
Table C-10
(4 of 8)
TDM/MCMP/Bridge Configuration Error Messages
Condition
TDM or MCMP mode: DCE (first port
on TDM/MCMP) was previously
selected as the first port in a
digital-sharing group when DSU was
operating in Bridge mode, and DSU is
now operating in TDM or MCMP
mode.
In TDM or MCMP mode, the first port
on the TDM or MCMP circuit card is
identified as 1.
Bridge mode: 1 (first port on
TDM/MCMP) was previously selected
as the first port in a digital-sharing
group when DSU was operating in
TDM or MCMP mode, and DSU is
now operating in Bridge mode.
In Bridge mode, the first port on the
TDM or MCMP circuit card is
identified as DCE.
MCMP mode: An attempt is made to
assign an invalid speed to a port.
Speeds of the individual channels can
be arbitrarily set to 2.4, 4.8, 9.6, 14.4,
19.2, or 38.4 kbps full-duplex.
July 1999
Diagnostic Control Panel Messages Reference
Action
Select 1 as the first port for the
digital-sharing group via the Setup
path in the MUX configuration
submenu.
Select DCE as the first port for the
digital-sharing group via the Setup
path in the MUX configuration
submenu.
You can correct the problem by
selecting 2.4, 4.8, 9.6, 14.4, 19.2, or
38.4 via the DSU path in the PrtSp
configuration submenu.
C-17