Model 3610 Circuit Card Switch And Jumper Locations; Model 3610 Dsu Jumper Straps - Paradyne COMSPHERE 3610 Operator's Manual

Table 2-2 lists jumper settings for the Model 3610
DSU. Figure 2-2 shows the location of these switches and
jumpers on the DSU circuit card. The jumpers labeled J14
through J16 are for factory testing only and must not be
changed. They should remain in the positions shown.
Strap
Designation
2
J12
2
J13
3
J14
3
J15
3
J16
1
Only service representatives are authorized to change jumper strap settings.
2
Moving the jumper to the right disables the Test Mode Indication.
3
Leave these jumpers in their factory-set positions.
4
The Installed or Removed state indicates the strap is 2-pin.
Figure 2-2. Model 3610 Circuit Card Switch and Jumper Locations
3610-A2-GB91-90
Table 2-2

Model 3610 DSU Jumper Straps

State Of
1
Jumper Strap
Left Enable V.35 Test Mode Indication
Left Enable EIA-232-D Test Mode Indication
4
Installed Factory Test
4
Installed Factory Test
4
Installed Factory Test
Two additional hardware straps, labeled J12 and J13,
control the Test Mode Indication feature for the V.35 and
EIA-232-D/V.24 DSU interfaces, respectively. When
enabled (as shown in Figure 2-2), V.35 lead NN and
EIA-232-D/V.24 Pin 25 go to ON (+EIA level) during
Test mode. When disabled, the leads are not connected
internally. The indicator lead for each interface can be
enabled or disabled independently.
Function
July 1999
Model 3610 Installation
2-5