Paradyne COMSPHERE 3610 Operator's Manual page 176

COMSPHERE 3600 Series Data Service Units
TDM/MCMP Port (MUX Funct: TDM or MCMP) Configuration Options*
DSR on Tst: Disab
Next Enab Disab
Data Set Ready On in Test . Controls the behavior of the DSR lead during testing.
Enab — DSR is ON continuously during testing, allowing a DTE that relies on DSR being ON to send
test messages to the DSU.
Disab — DSR is Off during testing.
Extend Chan: No
Next Yes No
4
Extend Main Channel .
DTE port of the tributary DSU and the DTE port of the extended DSU during a test condition.
Yes — Set this configuration option to Yes to extend main channel connectivity between the DTE ports
of the tributary and extended DSU in an extended network.
No — Set this configuration option to No if you do not have an extended network.
Upstrm Port:Prt1
Next Prt1 Prt2
Upstream Port . If an extended control DSU has its main (primary) channel connected to a tributary DSU and
the tributary's Extend Channel configuration option is set to Yes, set this option to the upstream port number.
Select Prt1 if the tributary DSU is operating in single port mode.
Prt1 — Selects the upstream port number. Ports 3—6 do not appear when a 2-port TDM/Flex or
to Prt6 MCMP/Flex is installed.
DTE Port: EIA232
Next EIA232 V.35
DTE Port . Selects the port data will be transmitted over. This configuration option appears for TDM/Flex and
MCMP/Flex applications.
EIA232 — Selects EIA-232 interface/connector operation for the port.
V.35 — Selects V.35 interface/connector operation for the port.
4
This configuration option is not displayed for a single-port multipoint tributary DSU of tributary with
Diag type set to Disr or None.
* The menu paths for Port 1 through Port 6 are identical.
6-48
Prev
Prev
Specifies whether an extended network has main channel connectivity between the
Prt3 Prt4 Prt5
Prev
Table 6-12
(5 of 5)
Prt6 Prev
July 1999 3610-A2-GB91-90