Abort; Device Test; Test Branch Menu Selections For The Dsu - Paradyne COMSPHERE 3610 Operator's Manual

Menu Selection

Abort

Terminate current test
Devic

Device Test

2, 3
LL Local Loopback
2
DTE DTE Loopback
2 ,3
DL Digital Loopback
2, 3, 4
RL Remote Digital Loopback
3,4
DT Digital Test
3, 4
EE End-to-End Test
3
BERT Bit Error Rate Test
Lamp Lamp Test
1
The Remote branch is not available from a tributary DSU in a multipoint configuration.
2
Accessed from the Loopback submenu (Lpbk).
3
When this test is executed on the aggregate data stream, secondary channel transport is lost and the
alarms No Response or TribTimOut are generated. Secondary channel is restored when the test is
aborted.
4
Not valid when the configuration option Diag Mode is set to None.
Abort
The Abort selection allows you to abort a test that is
running. The DSU is not allowed to run any other test
until the test in progress is aborted.
To access the Abort selection from the top-level menu,
make the following selections:
Local (F1), or Remote (F2) and Address
Test
DSU (select active core)
Abort
DSU Tests: E-E
Abort E-E
F1 F2
Press the F1 key to abort or cancel the test.
3610-A2-GB91-90
Table 4-5

Test Branch Menu Selections for the DSU

Test Required
F3
July 1999
Remote
Local DSU
1
DSU
X X
X X
X
X
X X
X
X
X
X X
X
DSU Abort Test:
Subn Selective
F1 F2
There are two types of selections to abort a test:
Selective terminates whatever test is in progress at
the local DSU.
Subn (Subnetwork) only displays at the control
DSU. This selection terminates any test running at
the control DSU or at a tributary DSU or DBM
associated with the control.
NOTE
The Subn selection is only
displayed at the control DSU.
DSU Operations
Per Port
X
X
X
X
X
F3
4-15