Dbm Configuration Options - Paradyne COMSPHERE 3610 Operator's Manual

Fast Sel: Enab
Next Enab Disab
Fast Select . Fast Select is a technique used by the Advanced Diagnostic protocol (ADp), the
COMSPHERE 6700 or 6800 Series NMS. When enabled, the DSU transfers a message to a downstream
device in a character-by-character format. When disabled, the DSU transfers the message to the
downstream device in packet or block format. The 3800 Series Dial Modem does not support Fast Select,
therefore, this configuration option must be disabled in all 3600 Series DSUs between the NMS and a
3800 Series Dial Modem on an extended circuit.
This configuration option does not appear if the DSU is a multipoint single-port device, if the protocol used is
DMC or DPII, or if Diag Type is set to Disr or None.
Enab — Enables the Fast Select feature.
Disab — Disables the Fast Select feature. When disabled, all devices on the same level of the circuit
must be disabled.
Rate(Kbps): 9.6
Next 14.4 12.0
1
DBM Rate . Initial data rate (in kbps) for dial backup calls.
14.4 — V.32bis modulation. This rate is not displayed for a 12.0 kbps DBM.
12.0 — V.32bis modulation.
9.6 — V.32bis modulation.
4.8 — V.32bis modulation.
2.4 — V.22bis modulation.
PrtSp(Kbps): 9.6
Next 56 48
9.6 9.2 8.4
2
Port Speed . If this value is set to less than the DBM rate, the DBM performs rate adaption. Rates above
14.4 kbps will only be displayed when a Switched 56 DBM is installed; 14.4 kbps will not be displayed for a
12.0 kbps DBM.
56 to — Selects the port speed.
1.2
Disab — Sets the port speed to 0.
1
Does not appear for Switched 56 DBM.
2
DBMs with firmware versions less than 2.0, with Rate(Kbps) set to 12.0, will also train at 9.6 kbps or
4.8 kbps, even when Single Rate is set to Yes.
3610-A2-GB91-90
Diagnostic General Configuration Options
Prev

DBM Configuration Options

9.6 4.8 2.4
38.4 32 28.8
7.2 4.8 4.4 4.0
Table 6-4
(4 of 4)
Table 6-5
(1 of 6)
Prev
19.2 18.8 18.0
2.4 2.0 1.2
July 1999
Configuration Options
16.8 14.4 12.0
Disab Prev
6-17