Paradyne COMSPHERE 3610 Operator's Manual page 223

Message
Sync Port Requir
Too Many Ports
Undersp Required
V.54&2500 Incmpt
10BPC & 2 Stops
3610-A2-GB91-90
Table C-10
(8 of 8)
TDM/MCMP/Bridge Configuration Error Messages
Condition
TDM mode: The sum of the port
speeds equals the DSU/DBM rate
and all ports are configured for
asynchronous operation.
TDM or MCMP mode: The Lowest
Port Number and Number of Ports in
Group specifications for a
digital-sharing group do not match
(e.g., Lowest Port Number: 4;
Number of Ports in Group: 5).
TDM mode: The sum of the port
speeds equals the DSU/DBM rate
and at least one port is configured for
synchronous operation, but no port is
configured for underspeed.
Disruptive diagnostic selection of
2500 is incompatible with V.54
diagnostics.
TDM or MCMP mode: An attempt is
made to configure the asynchronous
character format for 10 bits per
character plus two stop bits.
Two stop bits are not allowed when
the number of bits per character
is 10.
July 1999
Diagnostic Control Panel Messages Reference
Action
Correct the problem in one of two
ways:
1. Set the DSU or DBM rate
configuration option to a higher
value.
2. Lower the DSU/DBM port speeds
via the appropriate path (DSU or
DBM) in the PrtSp configuration
submenu and the Async rate.
Select new specifications for the
digital-sharing group via the Setup
path in the MUX configuration
submenu.
Configure the synchronous port to
underspeed via the appropriate path
(DSU or DBM) in the PrtSp
configuration submenu.
Configure Disr Type for any value but
2500.
Set the number of stop bits to "1" via
the appropriate path (Prt1—Prt6) in
the MUX configuration submenu.
C-21