Diagnostic Control Panel Messages Reference - Paradyne COMSPHERE 3610 Operator's Manual

Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DCP to Async Terminal Messages
Command Messages Format
Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Health and Status
Dial Backup Messages
TDM/MCMP/Bridge Messages
Overview
This appendix describes the messages that may be
displayed on the 3610 Series DSU's diagnostic control
panel (DCP) when the Async Terminal feature is in use,
while a command is executing, or when an error condition
prevents execution. The status, progress, or error
messages are described in this section. The messages
listed here do not include menus, data entry displays, or
specific test results.
Health and Status (H/S) branch messages are provided.
These include the Device (Devic) health and status,
Expanded (Expan) health and status, and Subnetwork
(Subn) health and status messages.
In addition, dial backup progress and error messages,
as well as time division multiplexer (TDM), multichannel
multipoint (MCMP), and digital bridge error messages are
included.
DCP to Async Terminal Messages
When the Async Terminal feature is in use, one of
three messages is displayed on the DCP. Table C-1
identifies and describes these messages.
3610-A2-GB91-90
Diagnostic Control Panel
Messages Reference
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DCP to Async Terminal Messages
Message
User I/F – Idle
User I/F – Activ
Term: Stndby
(appears under
the Term
submenu)
Command Messages Format
The format of the messages is shown below.
Command Name
Message
F1
July 1999
C
C-1
C-1
C-1
C-2
C-3
C-11
C-14
Table C-1
Condition
The async terminal is
enabled; the DCP is locked.
The async terminal is enabled
and a session is started.
The async terminal is enabled
but inactive, and DCP access
has been initiated and a valid
password entered at the DCP.
The async terminal is in
Standby mode.
If no key is pressed after
5 minutes, the DSU reverts to
User I/F – Idle.
F3
F2
C-1