Paradyne COMSPHERE 3610 Operator's Manual page 270

COMSPHERE 3600 Series Data Service Units
COMSPHERE
3600 Series 3600 Series
6700/6800
DSU DSU
ADp or DPII Mode
Display Call
Confg:Dir
Directory
Display Device
Confg:Opts
Options
Confg:PList Display Poll List
Display Port
Confg:Opts
Options
Display Port
Confg:Opts
Options
Display Telephone
Confg:Phone
Number(s)
Stat:DTE EIA/V.35 Status
End-to-End Block
Test:EE
Test
1
The disruptive effect of most commands depends on the position of the addressed device in the circuit and
the setting of the Diagnostic Type configuration option. Commands addressed to a control DSU use the
NMS control channel (CC) or diagnostic channel (DC), and are nondisruptive to the primary data channel.
Since a tributary is remote, commands addressed to it can be disruptive unless the associated DBMs are
in Standby mode or the DSU is configured for nondisruptive mode.
E = If the DSU is configured for disruptive or mixed diagnostics, this command may cause errors
requiring retransmission of data. If the DSU is configured for nondisruptive diagnostics, this
command will not cause errors in the user data.
N = Nondisruptive.
D = Session-disruptive.
4
For DSUs with firmware version 4.25 or greater, a 6700 or 6800 Series NMS Release 3.0 is required to
fully support this command functionality.
9
Command cannot be addressed to a tributary DSU by the ANALYSIS 6510 NMS if the firmware release is
less than 2.4.
10
When addressed to a DBM, the network returns the network address of the remote DBM if a backup call is
established.
11
Command is valid for an NMS with software version of less than 3.0. This command is combined with
Display Device configuration options in NMS Release 3.0.
H-4
Table H-1
NMS Command Set
System System
Controller Controller
—
Display Device
4
Options
10
Display Poll List
—
4, 11
—
4, 11
—
EIA Status
End-to-End
(3 of 4)
ANALYSIS ANALYSIS
6510 6510
—
Strap Device
10
—
—
—
—
—
—
July 1999
Disruptive
1
Effect
Control Trib
N E
9
N E
N N
N E
N E
N —
N E
D —
3610-A2-GB91-90