Paradyne COMSPHERE 3610 Operator's Manual page 179

Digital Bridge Port (MUX Funct: CBrdg or EBrdg) Configuration Options*
Extend Chan: No
Next Yes No
4
Extend Channel .
Specifies whether an extended network has main channel connectivity between the DTE
port of the tributary DSU and the DTE port of the extended DSU during a test condition.
Yes — Set this configuration option to Yes to extend main channel connectivity between the DTE ports
of the tributary and extended DSU in an extended network.
No — Set this configuration option to No if you do not have an extended network.
Upstrm Port:Prt1
Next Prt1 Prt2
Upstream Port . If an extended control DSU has its main (primary) channel connected to a tributary DSU and
the tributary's Extend Channel configuration option is set to Yes, set this option at the control DSU to the
upstream DSU's port number. Select Prt1 if the tributary DSU is operating in single port mode.
Prt1 — Selects the upstream port number. Ports 3—6 do not appear when a 2-port TDM/Flex
to Prt6 or MCMP/Flex is installed.
4
This configuration option is not displayed for a single-port multipoint tributary DSU or a tributary with
Diag Type set to Disr or None.
* For the DCE port (first port of the digital bridge), the Elastic Store is automatically enabled and RTS Control is
automatically set to =DTE. All other configuration options for the DCE port are turned Off. The menu paths for Port 2
through Port 6 are identical.
3610-A2-GB91-90
Table 6-13
(3 of 3)
Prev
Prt3 Prt4 Prt5
July 1999
Prt6 Prev
Configuration Options
6-51