Paradyne COMSPHERE 3610 Operator's Manual page 217

Message
DBM Aggreg Exceeded
DSU Aggreg Exceeded
DBM&CBRDG Incmpt
DDS must be 56k
DSD Speeds diff
DSD Wrong RTS
3610-A2-GB91-90
Table C-10
(2 of 8)
TDM/MCMP/Bridge Configuration Error Messages
Condition
TDM mode: The sum of the port
speeds is greater than the value for
the DSU or DBM configuration option
Rate(Kbps). Refer either to the DSU
or DBM configuration option tables.
MCMP mode: The sum of the
channel (port) speeds is greater than
48 kbps. The DDS line speed, set via
the DSU's rate configuration option,
must be set to 56 kbps; Rate(Kbps) is
a configuration option in the DSU
configuration submenu.
Bridge mode: An attempt is made to
configure a DSU equipped with a
DBM as a central-site bridge.
A DSU is not allowed to be
configured as a central-site bridge if it
is equipped with a DBM.
MCMP mode: The DDS line speed,
set via the DSU's rate configuration
option, is not set to 56 kbps. DSU
rate is a configuration option in the
DSU configuration submenu.
TDM or MCMP mode: Not all of the
ports in the digital-sharing group are
set to the same speed.
TDM or MCMP mode: One or more
ports in a digital-sharing group with
DSD port control have an incorrect
RTS Control setting.
Each port in a digital-sharing group
configured for contention must have
its RTS Control configuration option
set to DTE (RTS Cntrl = DTE).
July 1999
Diagnostic Control Panel Messages Reference
Action
You can correct the problem in one of
two ways:
1. Set the DSU or DBM rate
configuration option to a higher
value.
2. Lower the DSU/DBM port speeds
via the appropriate path (DSU or
DBM) in the PrtSp configuration
submenu.
You can correct the problem by
lowering the DSU port speeds via the
DSU path in the PrtSp configuration
submenu until the sum of the port
speeds is less than or equal to
48 kbps.
Remove the DBM.
Set the DSU's configuration option
Rate(Kbps) to 56 kbps.
Set all of the ports in the digital-
sharing group to the same speed via
the appropriate path (DSU or DBM) in
the PrtSp configuration submenu.
Set RTS Cntrl = DTE for all ports in
the digital-sharing group via the
appropriate paths (Prt1—Prt6) in the
MUX configuration submenu.
C-15