Paradyne COMSPHERE 3610 Operator's Manual page 127

Remote-Site Procedure
Request a Device Health and Status check (Devic from
H/S menu).
Local
Stat
H/S
Devic
H/S:
19.2
F1 F2
Check that the DDS speed is correct and that there are
no abnormal messages (refer to
the key to return to the top-level menu.
Perform a Device (Devic) Test to test the DSU and any
optional hardware (TDM or MCMP) that may be
installed, and verify that the devices are functioning
properly
Local
Test
DSU
Devic
The test results appear as shown in the following
screen.
Device: DSU
Pass
F1 F2
MUX is only displayed if a TDM or MCMP circuit
card is installed.
3610-A2-GB91-90
1:13:38
DDS
F3
Appendix C), then press
MUX
Pass
F3
If the device is not functioning properly, Fail appears
on the second line instead of Pass.
Press the key twice if a DBM is installed, and
perform a Device Test on it.
To add the tributary DSU with MCMP to the control
DSU's poll list on an MCMP circuit, make the following
selections:
Local
Confg
PList
Poll List:
Chang Add
F1
Add Self
Execute
F1
Add Self
Command Complete
F1
The Add command is executed. A message is sent to
the control DSU asking that the tributary be added to its
poll list. The control DSU responds by acquiring the
tributary DSU onto its poll list.
This completes the remote-site verification procedure.
July 1999
Operation Verification
Acq
F3
F2
PList:
F2 F3
PList:
F2 F3
5-5