Paradyne COMSPHERE 3610 Operator's Manual page 158

COMSPHERE 3600 Series Data Service Units
Async Sync: Disab
Next Enab Disab
Asynchronous-to-Synchronous Conversion . Sets Port 1 of the DSU for asynchronous or synchronous
operation. This configuration option is only displayed when the Single-Port Async/Sync feature is installed.
Enab — Configures the DSU as asynchronous (asynchronous-to-synchronous conversion takes place).
Disab — Configures the DSU as synchronous.
AsyncBit/Char: 8
Next 6 7 8
Asynchronous Bits per Character . Specifies the length of a character, including the parity bit but excluding
the start and stop bits. This configuration option is only displayed when the Single-Port Async/Sync feature
is installed and the Async Sync configuration option is enabled.
6 to 10 — Selects the asynchronous bits per character. When Stop Bits is set to 2, 10 will not be displayed.
Stop Bits: 1
Next 1 2 Prev
Stop Bits . Specifies the number of stop bits in an asynchronous character. This conversion option is only
displayed when the Single-Port Async/Sync feature is installed and the Async Sync configuration option is
enabled.
1 to 2 — Selects the number of stop bits to be used. When the AsyncBit/Char configuration option is set
to 10, 2 will not be displayed.
Overspeed: 2.3
Next 1.0 2.3
Overspeed . Selects the overspeed range of the asynchronous-to-synchronous converter. This conversion
option is only displayed when the Single-Port Async/Sync feature is installed and the Async Sync
configuration option is enabled.
1.0 — Selects the basic overspeed range. Basic range provides 1.0 % overspeed in the DTE
asynchronous data rate.
2.3 — Selects the overspeed percentage for extended range. Extended range provides 2.3 %
overspeed in the DTE asynchronous data rate.
6-30
Table 6-6
(8 of 8)
General Configuration Options
Prev
9 10 Prev
Prev
July 1999 3610-A2-GB91-90