Top-Level Menu Screen; Screen Types; Selection Screens - Paradyne COMSPHERE 3610 Operator's Manual

COMSPHERE 3600 Series Data Service Units

Screen Types

There are three types of async terminal screens:

Selection screens

Input screens
Display screens
Some functions operate the same throughout the
async terminal interface. These functions are the
following:
To return to the top-level menu from any selection
screen or from anywhere within the menu
hierarchy, enter T (or Ctrl-T). This is the same as
pressing the key if using the DCP. (The t can
be upper- or lowercase.)
To return to the previous menu, enter U (or
Ctrl-U). This is the same as pressing the
if using the DCP. (The u can be upper- or
lowercase.)
1 – Local
2 – Remot
PRESS Desired Selection Key
D-4
key
Customer ID: SITER818 Model: COMSPHERE 3610
Port1 DSU 9.6 C
Figure D-2. Top-Level Menu Screen
July 1999
To terminate a session, enter Ctrl-x. Refer to the
Terminating a Session
additional information.
Selection Screens
Selection screens display the selections available
through the menu tree. After password access, the
Top-Level Menu screen appears on the async terminal
(see Figure D-2). The unit's current configuration is
displayed below the line with Customer ID and Model.
This example identifies a control DSU with an operating
speed of 9600 bps.
To select from the menu, enter the number (or letter)
that corresponds with your desired selection (e.g., enter
1 to select the Local branch). No carriage return < CR>
is required.
T/ C t r l – T = Top Menu
U/ C t r l – U = Up Menu
C t r l – x = Disconnect
section of this chapter for
3610-A2-GB91-90