Transmitter Control - Paradyne COMSPHERE 3610 Operator's Manual

COMSPHERE 3600 Series Data Service Units

Transmitter Control

Transmitter Control (TxCtl) allows you to enable or
disable the DSU's or DBM's transmitter (DDS core), or
access the external leads of Port 1.
To access the Transmitter Control selection from the
top-level menu, make the following selections:
Local (F1), or Remot (F2) and Address
Ctrl
TxCtl
The Transmitter Control submenu in Local mode
differs from the one in Remote mode. Assume Local
mode in the following discussion until otherwise directed.
The following sequence of screen displays shows how
to disable the local DSU:
Change TxCtl of:
DSU DBM
F1 F2
DBM is only displayed if a DBM is installed, and if the
DSU is operating in Local mode.
DSU: Enable
Enab Disab
F1 F2
DSU: Disable
Command Complete
F1 F2
Press any key except the
Command Complete message.
When a control DSU is enabled, the entire network is
enabled. When the DSU is disabled, it will respond to
tests. If you abort the test, the test clears but the unit
remains disabled until you enable it.
4-36
Ports
F3
F3
F3
key to clear the
July 1999
To access the external leads (Port 1 in this example):
Change TxCtl of:
DSU DBM
F1 F2
Select Ports.
Port 1: Disable
Enab Disab
F1 F2
Port 1: Enable
Command Complete
F1 F2
The Transmitter Control submenu in Local mode
differs from the one in Remote mode.
For Remote mode, the following sequence of screen
displays shows how to disable the remote DSU:
Change TxCtl of:
Device Ports
F1 F2
Device: Enable
Enab Disab
F1 F2
Device: Disable
Command Complete
F1 F2
Ports
F3
F3
F3
F3
F3
F3
3610-A2-GB91-90